|
ALFA
AL - 35 Emulsion has been formulated specially as a release
agent/lubricant in a wide variety of cases. This milky white
liquid acts as a release agent for rubber stoppers, gaskets
on screw tops etc. |
| TYPICAL
PROPERTIES : |
| TEST |
RESULT |
| APPEARANCE |
MILKY
WHITE LIQUID |
| ACTIVE
MATERIAL CONTENT |
35
- 38 %w/w |
| SPECIFIC
GRAVITY AT 25oC/15.6oC |
0.98
- 1.0 g/ml |
| pH |
6.5
- 8.5 |
| EMULSIFIER
TYPE |
NON
- IONIC |
| DILUENT |
WATER |
|
| APPLICATION : |
|
AL
- 35 SILICONE EMULSION has been formulated as a release
agent/lubricant in a wide variety of cases, the following
are examples of many uses for this well-established product.
-
Mould
release agent
-
Release
agent for rubber stoopers, gaskets on screw tops and
bungs.
-
release
agent for tubes used in forming polyethylene and other
plastic bags.
-
Release
agent for extruded rubber parts and conveyor belts.
-
Textile
lubricant, reducing number of "runs" in
hosiery manufacture.
-
Textile
yarn and thread lubricant, reducing needle wear and
temperature, hence breakage of yarn/thread.
-
Lubricant
for glass fabric used in exhaust filters.
|
| HOW
TO USE : |
|
AL
-35 Emulsion should be diluted with water prior to use.
Recommended dilution is 1 part of Emulsion to 50 parts of
cold water. Users should evaluate on a test sample before
using in production.
|
| FEATURES
: |
- Good
emulsion stability : extended storage up to 54oC.
- Good
dilution stability ( 1 : 200 with water ).
- Surface
of mould becomes abrasion resistant and water repellent.
- General
Purpose release agent.
- Minimum
build - up on mould; moulded parts not discolored.
|
| HANDLING
PRECAUTIONS : |
|
Direct contact
with eyes may cause temporary discomfort which can be
relived by flushing them with water.
Safety
glasses should be worn when handling the emulsion.
|
